DryStoneGarden

Getting ready for the garden show, I’ve been having fun playing around with some large pieces of scrap basalt from the stone yard. Their fabrication shop has been making benches out of hexagonal basalt columns; they cut big rectangular pieces from the center of the hexagons and then sell off the parts that they cut away — the irregular outer ‘skin’ of the basalt column — for cheap. The skins are really interesting stuff, unusual shapes with a smooth cut face and several rough natural faces that contrast nicely with the cut face. I bought a bunch of the long pieces to use as a low retaining wall and edging, and also some randomly shaped ones to play around with. I need to make an upright fountain basin by the time I’m done, but to get used to the stone I made a couple easier pieces first.

I hadn’t really done this kind of stonework before. Building walls, I mostly just clean up the stones, shaping edges or squaring corners or removing high points. I hadn’t ever really tried to break into the mass of a stone like this, so I started with this relatively small, trapezoidal stone as an introduction. I scored a grid into it with a grinder and then knocked the pieces out with a point chisel. I hadn’t worked with true basalt before, and it has a much different feel from other stone I’ve worked with. It’s hard stone, with a high, glassy sound when I hit it, and it’s noticeably heavier than other stone, always taking a little more effort to move than I’m expecting. But the work actually went pretty quickly.

The photo above shows the basin after the first pass. I scored it a couple more times after that, making it deeper towards one end and in the middle. Apparently, larger birds like a two or three inch deep birdbath, while smaller birds like the water only an inch deep. So far, though, with it set up temporarily in our yard, I’ve mostly just seen our dog using it as a water dish, though I have found bird droppings on the rim, so I know at least one bird is using it. In the garden show I’m going to site it at ground level, but after the show I might give it some sort of pedestal to raise it up out of cat range. I still need to sand the rim to make it darker, and I might change the surface below the water level, where you can see chisel scars and one cut mark from the grinder. I could polish the part under the water so it gets dark and glassy, but I kind of like the chisel marks and I might pock mark the whole surface for a bigger contrast with the smooth rim.

After the trapezoidal piece, I moved onto this larger one. I liked its polygonal shape well enough, but I wanted to see if I could make it round. I thought I might have to cut around the edge with a grinder, but it was surprisingly easy to shape with a big handset chisel.

Like the trapezoid, it still needs to be polished. I’ll probably do that next weekend, and then a week after that it will be in the show. I’m pretty excited to see how it looks with plants around it. I’m about halfway finished with the fountain basin I need, and I have a large block I want to make into yet another basin, but so far the large block has pretty much laughed at my efforts to shape it (my sledgehammer broke instead of the stone). I’ll have the fountain ready for the show, but the block is probably going to sit in front of my house for a while. It’s been fun working on all of it, and should be fun finding a final home for each of the pieces after the show.

— Update — Here’s a photo of the finished piece in the garden show: